Exploring the general causes of air leakage in fully automatic horizontal molding machines

1. The pipeline of the fully automatic horizontal molding machine is damaged, especially in winter when the molding machine's air pipe is easily broken, causing air leakage in the molding machine pipeline.

2. We purchased inferior air valves instead of using good pneumatic components.

3. The cylinder processing of the molding machine is unqualified or the workshop fitter does not grind it finely.

4. The air pipe clamp of the styling machine was not installed properly, causing air leakage in the air pipe.

5. The air pressure of the compressor is too low, causing the airflow to reflux.

6. The air circuit of the air compressor carries water, which can block the muffler and cause air leakage.

The Qiaojie fully automatic series has many advantages:

Firstly, enterprises adopting automatic molding consumer lines are no longer limited to large backbone casting enterprises. A considerable number of enterprises have adopted automatic styling consumption lines;

Secondly, domestically produced automatic production lines have begun to provide stable supply to casting enterprises, and there are already four or five manufacturing plants in China that specialize in automatic molding lines based on consumer demand. However, in the entire automated consumption line, Chinese made products are still in the minority, and there are more low-level ones;

Thirdly, although there have been many automated production lines in the past, there are still a few casting companies that can fully utilize the design according to the production line. There are problems with not being able to fully control the use of automated production lines, as well as other processes that cannot effectively match the talent and pace of the production line